Box-Joint Jig By Dave (Vin) Vincent - valley@bicnet.net

"I made this jig from plans I found in WOOD Magazine issue 27 from February '89.

It easily sets up for any size finger, because with each revolution of the crank, the sliding block moves 1/16". I cut the fingers for 3 recipes boxes at the same time with perfect accuracy!

My jig is made of maple and finished with that Watco Danish Oil. There are simpler jigs for cutting this joint but this one is more versatile and of course half the fun of woodworking is using tools that you make."

This is a box Vin made with his jig. If you wish to check out a couple of examples of the work this jig can produce, click on the small photo to the left, and you will go to Dave's page in the U-Made-It Gallery. There will be a small photo of this jig to click on there, which will bring you back to this page, when you're done there.

To have another look at any of these jigs, please click on BACK below, and then choose the ones to see again. Or if you wish to proceed to the next area, click on HOME and them choose your next choice.

Email Webmaster
In an attempt to decrease the spam I get, my email address is
no longer clickable but instead is shown as an image in the box below.

If you wish to email me, please record the address below and email me there.